well I lack experience but even so nothing like this has not happened to me before, and certainly I am sure that it cannot be totally my fault...
 |
| from this angle all seems mostly fine |
Well what happened... warping and deforming on a grand scale. . :-( OK I think that perhaps the water I washed the kit in was to hot but the water must not have been much hotter than the water I used to clean my other kits, and they had no deforming, none what so ever. I am not put off Model Collect but I am going to be more cautious in future.
 |
| but on closer inspection things start to go wrong |
I do take responsibility for the water and I do know that this is mostly my fault, but even though that is the case, this is the same process I have used before with no problems, so perhaps I can ask to buy a replacement at a reduced price. Though even this might be a hard ask. I have never faced a situation like this and I am totally confused.
 |
| this part has suffered the worst... I have tried my best to correct the problems but the problems go beyond bending, the plastic itself has got weaker in some places |
 |
| heat can do this but it was |
now there is far more damage that this because all the spures also bent... once again this has never happened to me before. I have no chance of righting these wrongs because when I do, even by heating up the plastic again the plastic starts to come apart!
 |
| this is the most bizarre of the damage, I have managed to straighten out the tracks as much as possible but no joy. I know that tracks must be washed with care but again no problems in the past |
Well I have no clue what to do, but this is a slight warning if you get this kit watch out for the water temperature. I am going to try and sort this out myself but still some support/advice for what to do in future would be really appreciated.
well I hope you all have a better time than I have, Well perhaps the sand to mud charity run will take my mind off it, that's tomorrow I hope that I can give you some good news then.
0 Comments